Kohler K-97260X, Installation And Care Manual

Page: 8 / 24

Confirm Proper Operation
NOTE : Please read these steps carefully before you operate your dual system bath.
(refer to the “Switch Function and Operation” section)
□ Check all electrical connections, and make sure the electrical power to the whirlpool is turned on.
□ Make sure all union connections to the pump and heater are securely hand tightened.
□ Position the jet nozzles so they face down toward the basin. Turn the jet trim ring fully counterclockwise.
□ Fill the bath to a level above the top of the higher jet around 40 mm.
□ Press the Power On/Off button to turn on the whirlpool. The whirlpool will start at medium flow. Check all
bath piping connections, on the back side, for leaks.
□ Turn the jet trim clockwise to decrease the flow, and counterclockwise to increase the flow
□ Press the Power On/Off button a second time to turn the bath off.
NOTE : The water temperature in the bath should not exceed 40° C (104° F). The heater will automatically turn off
as the water temperature approaches 40° C (104° F), and will remain off until the water cools.
Complete the Brick
□ Cover the constructed brick with cement. Seal the joints between the bath rim edge and the brick with silicone
sealant.
□ Cover the outer side of the constructed brick with tiles. Seal the joints between the bath rim and tile with silicone
sealant.
Cement
Brick
Bath
Bath
Wall
Finished Material
Apply Silicone Sealant
Turn the jet trim ring counterclockwise
to increase the flow.
Turn the jet trim ring clockwise
to decrease the flow.
Fill with water (40 mm) above the highest jet.
Position the jet nozzles to direct
the water flow as desired.
Pop-Up Drain Control Knob
Turn counterclockwise
to close the pop-up drain.
Turn clockwise to
open the pop-up drain.
1241693-X2-B 8 Kohler Co.