1.
Install the Posts
Locate the Mounting Holes
IMPORTANT!
The slide bar must be mounted to stud framing supports at both the
top and bottom mounting locations. Do not use or depend on plastic wall anchors to
attach the slide bar.
NOTE:
The slide bar should not be installed in an area 24
″
(61 cm) to 48
″
(121.9 cm)
from the floor.
Mark the top mounting hole location then measure down 20-9/16
″
(52.2 cm) from
the first mark to determine the bottom mounting hole location. Verify both
marked locations are over a stud.
For tile or solid surface material:
Drill a 5/16
″
hole through the finished surface
only. Do not drill into the stud or the screws may not hold.
Install the Posts
Slide the pin over the screw.
Position the post over the top mounting hole.
Attach the post to the wall with the screw. Loosely tighten the screw.
Repeat for the installation of the bottom post.
Hold the slide bar up against the posts. Adjust the position of the posts until the
slide bar fits snug against the curved cutout of the posts.
Remove the slide bar and tighten the screws to secure the posts.
Installer les montants
Localiser les orifices de fixation
IMPORTANT!
La barre coulissante doit être montée aux support du cadrage de l’axe
aux deux emplacements de montage hauts et bas. Ne pas utiliser ni compter sur des
ancrages en plastique pour attacher la barre coulissante.
20-
9
/16"
(52.2 cm)
Mark the bottom mounting
minimum 48" (121.9 cm).
Marquer la fixation de base à
48" (121,9 cm).
Marque el montaje inferior
mínimo de 48" (121,9 cm).
Pin
Tige
Clavija
Post
Montant
Poste
Screw
Vis
Tornillo
Mounting Hole
Orifice de fixation
Orificio de fijación
1089626-2-A
4
Kohler Co.
