-13-
D. Activated mode
During the standby mode, press any button to the
, display the room temperature and
humidity. Display will be turned off if no any further action
within 10 seconds.
During the working mode, display the room temperature
and humidity. Display will be turned off after the
countdown finish.
Press the function button, the "beep will be heard.
activated mode
"
!
!
!
D.
10
!
!
!
E. Time setting
Setting time could be changed during the "HEATER",
"FAN , "DRY", "VENTILATION" and "AIR-CARE" mode.
Setting time will be changed back to the default after each
use.
"HEATER": the default time is 6 hours, minimum time is
10 minutes, and maximum time is 6 hours.
"FAN": the default time is 6 hours, minimum time is 10
minutes, and maximum time is 6 hours.
"DRY : the default time is 6 hours, minimum time is 10
minutes, and maximum time is 6 hours.
"VENTILATION": the default time is 6 hours, minimum
time is 10 minutes, and maximum time is 6 hours.
"AIR-CARE": the default time is 2 hours, minimum time is
10 minutes, and maximum time is 2 hours.
"24H VENTILATION": the default time is 6 hours, the
setting time cannot be changed.
"
"
!
!
!
!
!
!
!
!
E.
+
-
6
10
6
6
10
6
/
6
10
6
6
10
6
2
10
2
24
24
!
!
!
!
!
!
!
!
TROUBLESHOOTING
Problem
Diagnosis
Solution
Bathroom Heater does not
work.
The remote controller
does not display.
The remote controller
does not work.
Red LED is on.
Red LED is flash.
A. A power failure occurred.
A. The battery has been used up.
A. No pairing with the bathroom heater.
A. Temperature sensor error.
A. Dust filter need be clean.
B. The power cord is disconnected.
B. The polarity of battery was installed inversely.
B. The remote controller is used in an
inappropriate position or angle.
B. Humidity sensor error.
C. Circuit breaker is in the "Off" position.
C. No wake-up.
C. Low battery.
C. Heating system error.
A. Wait until the power is restored.
A. Please replace the battery.
A. Make the pairing.
Call the Customer Service Centre using the
information provided on the Compliance
Certification.
B. Connect the power cord into the junction box
of bathroom heater.
B. Please install the battery correctly.
B. Change the using position or angle to make
the controller towards the bathroom heater.
C. Turn on the power at the breaker.
C. Press any key to wake-up.
C. Change the battery.
A. Clean the filter or press the "+" for 2 seconds
in the Activated mode(Page 13).
1290505-T01-C
