1. Measure and Cut the Bottom Track
WARNING: Risk of personal injury.
Always wear safety glasses when cutting materials.
NOTICE: Risk of product damage.
Do not cut the top track at this time. The top track dimension is not
the same as the bottom track.
IMPORTANT!
If your shower has a curve in the corners where they meet the sidewalls, be sure to
measure from wall to wall above the curves. Failure to measure above the curve or angle could result in
the bottom track being cut too short.
Measure from wall to wall at the flattest part of the shower ledge (dimension
″
D
″
).
Mark dimension
″
D
″
on the bottom track.
IMPORTANT!
For best results, use a 32-teeth hacksaw blade and a miter box to cut the bottom track.
On the end opposite the mark, align the end of the insert flush with the end of the bottom track.
Subtract 1-1/8
″
(2.9 cm) from dimension
″
D
″
and simultaneously cut the bottom track and insert to
this dimension.
File the rough edges smooth where the bottom track was cut, taking care not to mar the finished
surface.
NOTE:
If there are curves where the sidewalls meet the threshold, use a file to contour the bottom track
edges to match the curves as necessary.
D
Measure
Here.
Measure
Here.
Measure distance
"D" above curves in
the corners.
Measure carefully. If your walls are curved or
angled, measure above the curve or angle. Failure
to do so can result in an improperly cut bottom
track and can void the warranty.
Curved Base
Important:
Angled Base
Kohler Co.
5
1054859-2-B
