Servicing the Filters
Turn off the water supply.
Remove the trim.
Close the stops following the directions in the previous section.
NOTE:
1/2
″
models do not have a locking assembly, 3/4
″
model
shown.
Insert a 3/8
″
square drive or 10 mm a hex wrench into the
appropriate stop (hot is left side, cold is right side) and remove it.
Remove the screen assembly by turning clockwise.
Clean or replace the screen assembly as needed.
Rotate the flow control clockwise 90° to close it.
Install the screen to the stop assembly.
Reinstall the screen assembly by pushing in and turning
counterclockwise.
Open the supply stops and check for leaks.
Reinstall the trim.
Stop and Screen
Assembly
Twist toward notch.
Remove screen.
1066046-5-B
6
Kohler Co.
