2. Supply Installation
CAUTION: Risk of restricted waterflow and product damage.
Use extreme care when bending the supply hoses to avoid
kinking and twisting. Hoses must not be taut after installation.
NOTE:
If the sink is not installed, install it at this time. Be sure to
follow all instructions packed with the sink.
NOTE:
If the sink installation requires that you coil the supply hoses
to obtain a good connection, maintain an inside coil diameter of at
least 3
″
(7.6 cm).
NOTE:
The most common type of faucet installation is with the
handle positioned to the right. Pull the handle for cold water or
push the handle for hot water. If the handle is installed to the left or
centered, reverse the supply tubes; connect the tube for cold water
to the hot supply and the tube for hot water to the cold supply. This
will maintain the relationship of pulling the handle for cold water or
pushing for hot water. If the handle is centered, press it to the right
for cold water or to the left for hot water.
Position the hot and cold water supplies to not interfere with
other hoses.
Connect the supply hoses to the supply stops. Left is hot, right is
cold.
Tighten all connections.
3" (7.6 cm)
or Larger
Cold
Cold
Hot
1013943-2-D
4
Kohler Co.
