Kohler K-6354, Installation Manual

Page: 5 / 20

1025491-2-
A
5
Kohler Co.
Compression
Fitting
Copper Tubing
Supply Tube
Coupling Nut
Ferrule
Coupling Nut
Ferrule
5. Connect the Supplies
CAUTION: Risk of restricted water flow and product damage. Use
extreme care when bending the supply tubes to avoid kinking.
-
Install the sink now, if necessary, using the sink manufacturer’s
instructions. Allow for required penetration of the supply tubes into
the supply stops. Cut the supply tubes as needed.
-
Slide the coupling nut, then the ferrule, onto the copper tubing. Set
the compression fittings over the copper tubing. Handtighten the
coupling nuts.
-
Slide a coupling nut, then a ferrule, onto each supply tube. Set the
compression fittings over the supply tubes. Handtighten the
coupling nuts.
NOTE
:
Do not apply torque to the supply fittings at the bottom of the
faucet while installing or tightening the compression fittings.
-
Carefully bend the supply tubes to align them with the supply stops.
Slide a coupling nut first, then a ferrule, onto each supply tube.
Insert the supply tubes into the supply stop outlets. Tighten all
coupling nuts.
6. Installation Checkout
-
Ensure that all coupling nuts are tight.
-
Ensure that the lever handle is in the down position.
-
Open the drain.
-
Remove the aerator from the end of the spout.
-
Turn on the main water supply, and open the valve for one minute to
flush the fitting.
-
Reattach the aerator. Turn on the water and check for leaks. Repair as
needed.