5. Operate the Steam Control
Steam Control Operation
NOTE:
The clock is always displayed when the steam generator is not in use.
Press the
″
Power
″
button to start the steam generator.
When the
″
Power
″
button is pressed the green light on the button turns on. The light remains on
until the unit is turned off. The display reads
″
On
″
for the first 3 minutes of operation if the settings
are not changed.
Press the
″
Power
″
button again to turn off the steam generator. The green light on the
″
Power
″
button will turn off and the display will read
″
Off
″
for 5 seconds, and will then return to display the
clock.
NOTE:
When the unit is turned on, the steam duration and temperature settings will be those of the
previous user’s settings. A new steam control unit comes pre-set to operate at 113°F (45°C) for 15 minutes.
Steam Control Operation
NOTE:
Make sure the steam control unit is turned on before making any of the following adjustments.
Press the
″
Temperature
″
button and the display will flash the previous temperature setting. To
adjust the steam room temperature, press the
″
Increase
″
or
″
Decrease
″
buttons to raise or lower the
steam room temperature. The maximum allowable temperature is 125°F (52°C), and the minimum
operating temperature is 90°F (32°C).
After 5 seconds, the flashing will stop and the room temperature will be displayed as it changes to
the target temperature.
Press the
″
Timer
″
button and the display will flash the previous run time setting. Press the
″
Increase
″
or
″
Decrease
″
buttons to adjust the time setting higher or lower. After 5 seconds the
flashing will stop and the timer setting will be displayed. If the
″
Increase
″
or
″
Decrease
″
buttons are
not pressed the time will continue to count down. The minimum operating time is 10 minutes, and
the maximum time allowed is 20 minutes.
Press the
″
Clock
″
button and the display will flash the currently set time of day. Press the
″
Increase
″
or
″
Decrease
″
buttons to adjust the time of day. After 5 seconds the display will stop flashing and
the set time will be displayed.
Press the
″
Power
″
button to stop the steam generator and exit the steam room at any time. The
display will read
″
Off
″
for 5 seconds and then default to the set clock time.
Change the temperature reading between Fahrenheit and Celsius by pressing and holding the
″
Temperature
″
button for 3 seconds.
Power Clean Function
Clock
Timer
Display
Temperature
Increase
Decrease
Power
1230489-2-C
8
Kohler Co.
