To troubleshoot this toilet you must first:
IMPORTANT!
Unplug the toilet or turn off the power.
If needed, turn on the water supply.
Plug the toilet back in or turn the power back on.
When the power is turned on, the toilet may flush three times and then function correctly.
No action is needed if this happens.
Note the results (how many times the toilet flushes, whether it operates normally).
Consult the chart above. Perform the recommended action.
13. Even though the
seat is occupied,
the spray function
does not work.
14. The hot blower
stops during use.
15. The deodorizing
blower feature
doesn't work.
16. The remote
controller does not
diplay.
17. The remote
controller does not
work.
18. Flushing function is
invalid.
A. The seat sensor may not be able to detect you
depending on the way you are sitting.
A. Four minutes after pressing the "Air Speed" icon,
blower automatically stops.
A. The seat sensor is not detecting the user.
B. Press "STOP"
A. The battery has been used up.
B. The polarity of battery was installed inversely.
C. No wake-up.
A. The remote controller is used in an inappropriate
position or angle.
B. Low battery.
C. The sensing window of remoate controller is
sheltered or coved by dirts.
A. The "Auto Flushing Function" has been turned
off.
B. It will not flush in 60 seconds after having
pressed the key of "Manual Flushing" on remote
control.
C. The bidet seat and the toilet are not properly
connected.
A. Change the way you sit.
A. Press the "AIR TEMP" button again.
A. See activating the seat information in the
"Operation" section.
B. Same as above.
A. Please replace the battery.
B. Please install the battery correctly.
C. Press the wake-up key.
A. Change the using position or angle to make the
sensing window towards the ceiling or the
product's sensing window.
B. Change the battery.
C. Hold the remote controller properly or remove
the shelter.
A. Turn the "Auto Flushing Function" on.
B. Refer to "Toilet Flushing".
C. Check and reconnect.
-16-
1144585-T01-A
