-8-
(3) Demount five decorative screw covers.
(3)
5pcs
(5) Push the bathroom heater to hole and install the
ventilation outlet assembly first with 1 ST 4.2*8 self-
tapping screw.
(5)
,
ST4.2*8
(1pc)
Decorative Screw Cover
(4) Fix the power cord to the bathroom heater
(I)
Remove the screw on the wiring cover plate.
(II) Open the wiring cover plate.
(III) Lift the terminal protection cover.
(IV) Loosen the screw fixing the power cord clip.
(V) Loosen the screw on the wiring terminal, insert the
power cord (not supplied) connected to the indoor
fixed line into the wiring terminal, tighten the wring
terminal screw.
(VI) Fix the power cord with power cord clips. (The
power cord clip must pin the insulation sheath of
power cord.)
(VII) Use the screw removed in step (I) to fix the wiring
cover plate again.
(4)
(I)
(II)
(III)
(IV)
(V)
(
)
(VI)
(
)
(VII)
(I)
Power Line
Terminal
Junction Box Cover
Wire Clamp
ST2.9*7 Self-tapping Screws
ST2.9*7
Installation Hole
Ventilation
Outlet Assy.
Plasterboard
Ceiling
Push-in
ST4.2*8 Self-tapping Screws
ST4.2*8
Ventilation Air Outlet
Panel Base
Ventilation Outlet
Assy. Hook
Groove
1373009-T01-A
