3
1018323-2-
A
Kohler Co.
5.
Square frame to rim of bath/whirlpool.
6.
Secure sides of apron frame to studs with screws
provided. Shim if necessary to fill any gap(s).
7.
Secure bottom of apron frame to subfloor with
screws or floor anchors. Shim if necessary to fill any
gap. Some shimming (approximately 1/2” (1.3cm))
will be necessary if installing your apron on
K-1266/67 Dockside bath/whirlpool.
8.
Thread the carriage bolt out until it makes contact
with the bath. Then secure by threading the nut up
against backside of brace.
Stud
Screw
Apron Frame
Bath
Subfloor
Square
Shim (if
necessary)
Carriage Bolt
9.
Install apron panel by centering on apron frame.
Press panel onto frame so each of the fasteners
located on the backside are engaged.
Apron Panel
Apron Frame
Fastener
10. Install wall covering and flooring. Maximum wall
thickness is 1-1/2” (3.8cm). Maximum floor
thickness is 2” (5cm).
REMOVE THE APRON
When servicing the unit, pry bottom of panel gently using
a flat-blade screwdriver.
Apron Frame
Apron Panel
Screwdriver