8. Install the Whirlpool Trim Kit
Install the whirlpool trim kit according to the instructions packed with the trim kit. Pay particular
attention to the jet installation steps below - they are very important and are included here to help you
obtain smooth, trouble-free jet operation. When installed correctly, the jet should turn smoothly both
clockwise and counterclockwise.
NOTE:
The jet O-ring must be carefully positioned, lubricated, and be in good condition to permit easy
rotation and proper operation of the jet.
Lubricate the O-ring with silicone lubricant to prevent noisy operation of the jet.
Install the O-ring onto the
first shoulder
of the jet.
Carefully insert the jet into the housing, and lightly push and rotate the jet until it snaps into
position.
Do not force the jet into place.
9. Test Run the Whirlpool
Check all electrical connections, then make sure all union connections to the pumps and heaters are
securely hand tightened.
Verify both sets of pump banding straps have been cut and the pump controls are resting directly
on the subfloor. Ensure the rubber isolation feet are in place.
Turn electrical power to both pumps on.
Fill the whirlpool with water until the water level is above the highest backjet.
Operate the whirlpool for 5 minutes (refer to the
″
Operating Sequence
″
section). Three small lights
near the whirlpool floor will illuminate as long as the keypad remains lit. The keypad controls the
chromatherapy feature.
Check for leaks coming from the piping connections on the back side of the whirlpool unit.
Turn on the each of the whirlpool features and verify proper function. Check for any water leakage
on the whirlpool’s back side.
Turn on the chromatherapy cycle and allow it to sequence through all eight colors; white, violet,
indigo blue, aqua blue, green, yellow, orange and red. It takes approximately 1 minute to cycle
through all eight colors.
Verify functions using the remote controls. Refer to the
″
Remote Control Operation
″
section of this
guide and supplemental instruction sheet,
″
Programming Your Remote Controls
″
, packed with your
literature.
NOTE:
For additional information on whirlpool operation, see the
″
Confirm Proper Operation
″
section of
this guide.
Slide the O-Ring
onto the first
shoulder of the jet.
Inspect and
lubricate the
O-Ring.
Insert the jet into the housing,
and lightly push and rotate
until it snaps in position.
Housing
1042760-2-C
10
Kohler Co.
Summary of Contents for K-1111-VLN
Page 59: ...1042760 2 C ...
