User Keypad And Bath with Airjets Modes/Features
Power On/Off -
Turns the blower motor on and off. Symbols illuminated in blue indicate available
modes/features. Modes which are operating will display in green.
Activate Button -
Press “OK” to activate the desired mode. The active mode will flash (green).
Up Arrow -
Increases the air flow when the air flow mode is active. Increases the pulse speed when
the surge mode is active.
Down Arrow -
Decreases the air flow when the air flow mode is active. Decreases the pulse speed
when the surge mode is active.
Outer Ring -
Rotate the outer ring to the desired mode. The selected mode will flash (blue).
Indicator Bar -
Shows the air flow volume when operating in the air flow mode. Shows the surge
speed when operating in the surge mode.
Purge Mode -
Select to initiate the purge mode manually. The purge cycle will not start if there is
water in the bath with airjets. The purge mode blows any residual water out of the air channels.
The blower motor starts and runs at a low speed for about two minutes. An automatic purge cycle
occurs when the bath is drained and the water level falls below the level sensors.
Air Flow Mode -
In this mode, air flow is directed through any combination of the air jets in the
selected zones. Air flow can be adjusted with the arrow buttons. When the surge mode is selected,
the air flow mode stops. When the air flow mode is selected while operating in the surge mode, the
surge mode stops.
Zone 1 -
This mode is used to select or deselect the air flow through Zone 1.
Zone 2 -
This mode is used to select or deselect the air flow through Zone 2.
Zone 3 -
This mode is used to select or deselect the air flow through Zone 3.
Surge Mode -
When active, the air flow ramps up from minimum to maximum and then down
again to minimum. The surge speed is adjustable between approximately 10 seconds to 60 seconds
by using the up or down buttons. The up and down arrow buttons can be used to adjust the surge
speed. Zones can be selected or deselected when in the surge mode.
Chromatherapy Cycle (if provided) -
Chromatherapy lights will automatically and continuously
cycle through the eight colors; white, violet, indigo blue, aqua blue, green, yellow, orange and red.
One cycle through all eight colors takes approximately one minute.
Chromatherapy Specific-Color (if provided) -
When this mode is selected, you may choose a
specific color for the bath.
Air Flow Mode
Activates Mode Selected
Power On/Off
Indicator Bar
Decrease Flow or Surge
Increase Flow or Surge
Rotating Ring Key Pad
Zone 1
Zone 2
Zone 3
Surge Mode
Purge Mode
Chromatherapy Specific
Color (if provided)
Chromatherapy Cycle
(if provided)
Rotate Outer Ring to
Access Desired Mode
1038364-5-A
6
Kohler Co.
Summary of Contents for K-1110
Page 54: ...1038364 5 A ...
Page 55: ...1038364 5 A ...
