Operation
NOTE:
If the whirlpool is not operating properly, consult the
″
Troubleshooting
″
section of this guide
before calling a qualified service representative.
Whirlpool
NOTICE:
Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will
automatically maintain the water temperature when the whirlpool is running, as long as the water
temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.
Close the drain, then fill the whirlpool to a level at least 2
″
(5.1 cm) above the highest effervescent
port. Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Press the power icon to turn on the whirlpool pump and heater. Water will flow at medium volume.
Press the up or down arrow icons to increase or decrease the water flow. The indicator bar will
display the water flow volume.
If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the
heater back on.
Press the power icon a second time to turn off the whirlpool pump and heater.
NOTE:
The pump and heater will automatically stop after approximately 20 minutes of continuous
operation. If desired, press the power icon to reactivate the pump and heater.
Carefully exit the bath, then open the drain to empty the whirlpool.
Effervescence
Rotate the outer ring until the effervescence icon is flashing, then press OK to activate the
effervescence ports. The water flow volume will remain as previously set. Press OK while the
effervescence mode is flashing to turn off the effervescence ports.
Chromatherapy
NOTE:
The chromatherapy modes may be used with all modes of operation, even when the pump is not
operating.
Rotate the outer ring to select the chromatherapy mode, then press OK to activate the
chromatherapy lights. Press OK while the chromatherapy mode is active to turn off the
chromatherapy lights.
Rotate the outer ring to select chromatherapy specific color selection, then press OK. Use the up or
down arrow to reach the desired color. Press OK while the chromatherapy specific color selection is
active to turn off the chromatherapy lights.
Kohler Co.
5
1023261-5-C
Summary of Contents for K-1110-CT
Page 49: ...1023261 5 C...
Page 50: ...1023261 5 C...
Page 51: ...1023261 5 C...
Page 52: ...USA Canada 1 800 4KOHLER M xico 001 800 456 4537 kohler com 2009 Kohler Co 1023261 5 C...
