1. Install the Control Stop
For K-10959 only
IMPORTANT!
Flush the water supply line and then turn off the
water supply.
Cut the water supply tube and sweat solder the 3/4
″
male NPT
threaded adapter to it.
NOTE:
Install the threaded adapter so the centerline of the
externally threaded control stop arm matches the centerline of the
spud when assembled.
Place the wall flange over the water supply tube and slide it
against the finished wall.
Place the sleeve over the water supply tube. If required, cut the
sleeve to size.
NOTE:
Use thread sealing compound only on male NPT threads.
Apply thread sealant to the male NPT threaded adapter.
Thread the control stop valve onto the threaded adapter.
Thread the stop cap onto the control stop using a strap wrench.
Align the outlet to the valve inlet and use a strap wrench to
tighten the control stop.
Wall Flange
Sleeve
Control Stop
Stop Cap
1061437-2-C
4
Kohler Co.
