1250176-2A-A
2
1250176-2A-A
3
INSTALLATION
How to Install the Spout
Install the stud(1) and washer(2) into the bottom of
faucet(3). Insert hoses(4) and stud into the hole of
lavatory. Insert the lift rod(5) into the hole at the rear
of the faucet.
From underside of the lavatory, fit the bracket(6) onto
the stud. Position the faucet. Install the washer(7) and
nut(8) onto the stud, tighten the nut by tool(9) to
secure the faucet.
Attach the hoses to water supplies, the hose with
“COLD” label connects to cold water.
Remove the retaining nut(18) and ‘V’-clip(17). Fit the
plastic washer(19) and retaining nut onto the ball
lever(20). Insert the ball lever assembly into the drain
lever hole and through the stopper hole. Tighten the
retaining nut.
Be sure that the ball lever(20) points to the back of the
lavatory, tighten the locknut(13) on the drain body by
wrench.
NOTE:
Do not reposition the drain if plumbers putty
applied after the locknut is tightened, or you may
break the putty seal. Wipe away excess plumbers
putty.
How to Install the Drain
Remove stopper(15), flange(10) and washer(11) from
drain body(14). Insert drain body kit into the lavatory
from underside, and make sure the drain lever
hole(12) facing to the back of the lavatory. Screw the
flange with washer into the drain body. Tighten the
locknut(13) by hand from the underside of the fixture.
NOTE:
If needed, apply a ring of plumbers putty
around the underside of the drain flange(10), instead
of using washer(11).
Place stopper(15) into drain body aligning the flat side
of stopper hole(16) with the drain lever hole.
Ensure that all coupling nuts are tight. Ensure that the
lever handle is in the off position.
Turn on the main water supply and drain, and check
for leaks. Repair as needed.
Remove the aerator(22) by key(23). Run hot and cold
water through faucet for about one minute to remove
any debris. Check for leaks. Repair as needed.
Remove any debris from the aerator. Shut off the
faucet. Reinstall the aerator.
Assemble thumb screw(21) to link(22), and link onto
ball lever(20) with ‘V’-clip(17).
Slide lift rod(5) through the hole of the link. Push the
ball lever down into the open position. Position the lift
rod. Tighten thumb screw(21).
INSTALLATION CHECKOUT
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
15
16
11
11
3
2
1
4
7
6
8
5
9
10
10
14
13
12
19
12
20
18
17
13
22
23
5
20
22
17
21
