Kohler EIR, Homeowner'S Manual

Page: 8 / 48

停止
L - Sterilization function
Press this button to perform wand and bowl overall clean function. (Note: seat/cover open/close by remote
N - Seat temp
Press this button to adjust seat temp dial, press +/-
（
Q+/Q-
）
to adjust seat temp.
O - Water pressure
Press +/-
（
Q+/Q-
）
to adjust water pressure when front wash or rear wash is activated.
P - Nozzle move
Press +/-
（
Q+/Q-
）
to adjust nozzle position when front or rear wash is activated.
Q - parameter adjustment button Q+/Q-:
Only when M/N/O/P function is activated, the +/- button shall be activated and perform corresponding
parameter adjustment.
when the function is in process. The function shall be disabled when seated.)
M - Water temp
Press +/-
（
Q+/Q-
）
to adjust water temp when front wash or rear wash is activated.
Note: please charge in time when the voltage alarm is activated.
When button blinks, it indicates that the built-in battery in the remote control is almost used up. Attach the
remote control to the docking station and allow it to charge.
Note: pairing operation can only be done under unseated status.
Cover and seat is powered on, press boot button on remote top. When the bottom roll of icons blink for a long
time this indicates remote require pairing with the toilet.
Push and hold button, after the bottom roll of icon blinking, the toilet operation start.
Push and hold and button on toilet side panel simultaneously, release button after hearing a short beep.
When the bottom-roll of icons on remote stop blinking, it indicates pairing successful.
When remote move away from sensor area, the bottom roll of icons on the remote will auto blink (indicate
searching for toilet signal). When move remote close to toilet, the signal will auto connect, icons stop blinking
after successful connection.
Whenever Push and hold button, remote enter OFF status.
Low voltage alarm
Pairing
Communication between remote control and toilet
Deactivation function
停止
1413624-T01-B 8 Kohler Co.