4. Prepare the Site
CAUTION: Risk of hazardous gases.
If the new toilet is not installed immediately, temporarily
place a rag in the closet flange.
NOTE:
If the rough-in distance is less than 12
″
(305 mm) the seat may strike the wall when it is opened.
Confirm that the rough-in is 12
″
(305 mm) before installing the toilet.
Remove the old toilet.
Remove the wax residue from the flange.
NOTE:
Do not install the wax ring at this time.
Install two 5/16
″
diameter x 2-1/4
″
long T-bolts into the floor flange.
Set the adapter in place over the flange as shown.
Mark the adapter rear mounting hole.
Kohler Co.
7
1295780-2-A
