4
TT-1606 5/16
2.3 Position the internal rails (GM89774 qty. 4) at the
location shown in Figure 4 using the mounting
bracket and hardware identified in Figure 6.
Nonservice-side internal rails (GM89774 qty.
2):
Position a mounting bracket (GM86091) to the
top of each internal rail using three bolts
(X-6224-20) and three nuts (X-6210-7) per
bracket. See Figure 13 for more detail.
Service-side internal rails (GM89774 qty. 2):
Position a mounting bracket (GM86091) to the top
of the internal rail using four bolts (X-6224-20) and
four nuts (X-6210-7) per bracket. See Figure 13
for more detail.
Note:
Do not final tighten at this time.
GM86396A-
1. Bolt (X-6238-3 or X-6238-11 qty. 4) and washer (X-25-37
qty. 4)
2. Bolt (X-6224-20 qty. 8), nut (X-6210-7 qty. 8), and washer
(X-25-37 qty. 8)
3. Corner extrusion mounting bracket (GM85875 qty. 4)
1
2
3
Figure 5
Corner Extrusion Mounting Bracket
Installation (Corner Rails to Base, 4 Places)
GM86396A-
1. Extrusion mounting bracket (GM85876 qty. 4)
2. Bolt (X-6224-20 qty. 8), nut (X-6210-7 qty. 8), and washer
(X-25-37 qty. 8)
3. Bolt (X-6238-3 or X-6238-11 qty. 8) and washer (X-25-37
qty. 8)
1
2
3
Figure 6
Extrusion Mounting Bracket Installation
(Rails to Base, 4 Places)
2.4 Position the LH and RH bulkheads (GM89860 and
GM89861) as shown in Figure 4 (items 7 and 9).
Secure the bottom of the bulkheads to the existing
skid using a screw (M933-06020-60), washer
(X-25-40) and nut (M6923-06-80) for each
bulkhead.
Secure the sides of the bulkheads to the two
internal rails using a bolt (X-6224-20), washer
(X-25-37), and nut (X-6210-7) for each bulkhead.
2.5 Position the upper bulkhead (GM89859) as
shown in Figure 4 (item 4).
Secure the bottom of the upper bulkhead to the LH
and
RH
bulkheads
using
two
screws
(M933-06012-60) and two washers (X-25-40) for
each bulkhead.
Secure the sides of the upper bulkhead to the
internal rails using a bolt (X-6224-20), washer
(X-25-37), and nut (X-6210-7) for each side rail.
Summary of Contents for 125EFOZDJ
Page 15: ...15 TT 1606 5 16 Notes ...
