Kohler 10RESV, Operation, Page: 36 / 76

TP-6880 10/14 36 Section 3 RDC2 Controller Operation
3.7 RDC2 Controller Menus
Controller menus display power system information,
including status information for the engine, generator,
and optional RBUS accessories, exercise settings, and
event history. Some menus allow changes to the
controller settings. Status information, including the
engine runtime, cannot be changed by the operator.
Diagrams in the following sections show how to navigate
through the menus.
Note: Use caution when navigating the controller
menus. In some menus, pressing the Select
button can enable editing of the controller
settings. Changing the settings to incorrect
values can adversely affect generator set
operation or render the unit inoperable.
If a setting on the controller display is flashing, edit mode
has been enabled. Press the OFF or AUTO button to exit
the edit mode.
3.8 Main Menu
Press the Select button once to bring up the main menu.
Overview is displayed. See Figure 3-9. Press the down
arrow button to step to the next menu, Engine Metering.
Use the UP and DOWN arrow buttons to step up and
down through the menus shown in Figure 3-9.
The controller will exit the main menu after 5 minutes if
no buttons are pressed. To exit the main menu
immediately, press the controller’s OFF or AUTO
button.
Overview ---->
1.2 h
Engine ---->
Metering
tp6804
Generator---->
Metering
Genset ---->
Information
Genset ---->
Run Time
Date ---->
and Time
ATS ---->
Configuration *
Genset ---->
System
Event Log---->
Load ---->
Control
]
PIM ---->
Status
[
Network ---->
Information
Status
Displays
ATS ---->
Status
* ATS Configuration appears only if a Model RXT transfer switch is connected.
[
PIM Status appears only if a programmable interface module is connected.
]
Load Control appears only if a load control module (LCM) or load shed kit is connected.
Press the Up and Down arrow buttons
to move between menus.
Press OFF or AUTO to exit the menus.
Figure 3-9 RDC2 Main Menu