Handling Instructions and Precautions
1.
Always thoroughly blow off (use compressed air) the tubing
before connecting it to the rodless cylinder. Entering chips,
sealing tape, rust, etc., generated during piping work could
result in air leaks or other defective operation.
2.
When screwing piping or fittings to rodless cylinders, tighten
them using the following tightening torques.
Connecting thread
M5
×
0.8
Rc1/8
Rc1/4
Rc3/8
Tightening torque
N
・
m [ft
・
lbf]
1.57 [1.16]
6.77
〜
8.63 [4.99
〜
6.37]
11.57
〜
13.44 [8.53
〜
9.91]
21.18
〜
23.05 [15.62
〜
17.00]
General precautions
Piping
Lubrication
1.
The product can be used without lubrication, if lubrication is
required, use Turbine Oil Class 1 (ISO VG32) or equivalent.
1.
If using in locations subject to dripping water, dripping oil,
etc., or to large amounts of dust, use a cover to protect the
unit or mount with the piston yoke facing downward.
2.
Do not engage in electric welding close to the slit type
rodless cylinders
ORV
series. The welding spatters could
damage the outer seal band.
3.
The product cannot be used when the media or ambient
atmosphere contains any of the substances listed below.
Organic solvents, phosphate ester type hydraulic oil, sulphur
dioxide, chlorine gas, or acids, etc.
Atmosphere
1.
Use air for the media. For the use of any other media,
consult us.
2.
Air used for the slit type rodless cylinders
ORV
series should
be clean air that contains no moisture, dust, and oxidized oil,
etc. Install an air filter (filtration of a minimum 40 µm) near
the slit type rodless cylinders
ORV
series or valve to remove
collected liquid or dust. In addition, drain the air filter
periodically.
Media
1050̲1053ORVｼﾘｰｽﾞ̲ENG 07.9.10 1:57 AM ページ1053
