background image

Flight Adjustments and Settings

To get familiar with the operations, practice operating the controls as shown below in a large open area. 
Keep practicing the manoeuvrers until you can perform them as they are being called out.

Notes for Beginners

Check to make sure all screws are tightened.

Check that the remote control and quad-copter are both fully charged.

Make sure that no people or obstructions are nearby.

Practice safe hovering before moving on to harder tricks.

Stand approximately 2m diagonally behind the quad-copter

When the four lights on the bottom of the quad-copter all flash, it means the battery is running low.

Troubleshooting

Problem

Cause

Possible Solution

Lights on quad-copter blink continuously 
for 4 seconds once turned on. No response 
to controller input.

Unable to pair with the remote control.

Repeat the power up and initialisation 
process. 

No response after batteries are inserted into
the remote control.

Check power of both remote 
control and quad-copter

Poor contact on battery 
terminals.

Fully charge the quad-copter and 
replace batteries in remote.

Reseat the batteries and ensure 
the contact is good.

Motor not responding to throttle stick.

Helicopter battery depleted.

Fully charge the batteries.

Main blade not turning.

The main blade and motor are not 
assembled correctly.

Lift the main blade up to give appropriate 
clearance.

Main rotor spins but quad-copter will not 
take off.

Deformed main blades.

Helicopter battery depleted.

Replace blades.

Charge helicopter fully.

Quad-copter is shaking violently or lunging 
sideways.

Main blade is out of shape.

Replace main blade.

Tail remains off-trim after adjustment, or 
inconsistent speed during left/right 
pirouette.

Damaged tail rotors.

Damaged tail drive motor.

Replace the main wing.

Replace the main rotor.

Quad-copter still wanders forward after trim
adjustment during hover.

Gyroscope has not been calibrated 
correctly.

Turn quad-copter off, then turn it on and 
place it on a flat surface and do not move it 
while it recalibrates.

4

Summary of Contents for KARTUFONNA






Reviews: