Water Connection
Before beginning:
•
Disconnect from power.
•
Water hazards!
The water pressure of the appliance is 147-834KPa (1, 5-8.5kgf/cm). If the water
pressure is too high, install a decompressor.
•
Do not connect the appliance to a tap of the water heater.
Do not bend inlet pipes and drain-pipes during placement: carefully connect water
pipes.
•
Do not use any old and used water pipes. Purchase the joint to connect the pipe
and the water tap and install it according to the schematic diagram.
•
After being used for 6 consecutive months, the icon (l=J) on the display panel will
blink: this indicates the water filter should be replaced.
Connection of the Water Facility (Fig. 1)
1.
Push the end of the connecting hose into the joint. Fasten the joint to the water
tap.
2.
Remove the pipe cap from the white flexible hose.
Push the end of the white flexible hose into the hose connector, fastened with the
snap ring. If necessary, rivet the flexible hose onto the wall.
3.
After the pipes are connected, carefully unscrew the water tap to ensure the
pipeline is sealed.
Joint
Connecting Hose
Hose Connector
Snap Ring
Pipe Cap
