Before Using Your Kettle
If you are using the kettle for the first time, it is recommended that you should clean your
kettle before use by boiling the Max capacity of water once and then discarding the water
twice. Wipe the surface with a damp cloth.
The maximum capacity of this kettle is 1.7 litres.
Using Your Electric Kettle
1.
Place the kettle and power base on a flat surface.
2.
To fill the kettle, remove it from the power base and open the lid by pressing down
lid release button, then fill the kettle with the desired amount of water and close
the lid. The water level must be within the Min and the Max level. Too little water
will cause the kettle switching off before the water has boiled.
3.
Position the kettle on the power base.
4.
Connect the plug into a power outlet. Press down the switch and the indicator will
light up and then the kettle starts to boil the water. The kettle will switch off
automatically once the water has boiled.
If necessary, it will take you 30 seconds to wait before pressing the switch again to
re-boil the water. You may shut off the power by lifting switch up or directly lift the
kettle from the power base at any moment to stop boiling process.
5.
Lift the kettle from the power base and then pour the water.
6.
The kettle will not re-boil until the switch is pressed again.
The kettle may be stored on the power base when not in use. Always disconnect the power
supply when not use.
OPERATION
Note:
Do not fill the water over the ‘maximum’ line, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place before plugging the power outlet.
Note:
Ensure that switch is free of obstructions and the lid is firmly closed, the kettle will not
turn off if the switch if be constrained or if the lid is opening.
Note:
Operate carefully when pouring the water from your kettle as boiling water may result
in scald, besides, don’t open the lid while the water in the kettle is hot.
