EN
User manual
Steady Pro® range
KMAN-5001_V6.1_EN
2019.04.30
KOELIS 16 chemin du vieux chêne 38240 Meylan France
6
/
13
Year of CE marking : 2017
Steady Pro® s
upport’s assembly
Setting of the Steady Pro® support on KPHA.00 (Valid for KPHA.EC.2 and KPHA.EL.2)
1)
Lift and hold the outer part of the tip and clip it into the head of the Steady Pro® Probe holding arm and untighten the outer part
of the tip. (Fig. 4.a and 4.b)
2)
Ensure it is secured by turning the external part. It should be fixed. (Fig. 4.c)
Placement of the probe on the Steady Pro® support
KPHA.EC.2
1)
Position the probe in the direction illustrated by the diagram outside of the internal part. (Fig.5.a)
2)
Assemble both internal components around the end-fire probe. (Fig.5.a)
3)
Loosen the screw of the external component and insert the internal components into the external part. (Fig.5.b)
4)
Tighten the screw of the external component to secure the internal components.
(Fig.5.c)
KPHA.EL.2
1)
Unscrew the inferior screw of the internal component.
2)
With the washer on the outside, screw the inferior screw through the rail of the external part and in the internal part. (Fig.6.a)
3)
Position the internal component so that
“
KOELIS
” and “BACK”
is facing you. (Fig.6.a)
4)
Loosen screw number 2 and open the internal component. (Fig.6.b)
5)
Insert the side-fire probe.
(Fig.6.b)
6)
Tighten screw number 2. (Fig.6.c)
Figure 6
a.
b.
c.
Figure 5
a.
b.
c.
c.
Figure 4
a.
b.
Screw 2