Koden MDS-1100R Series, Installation Manual

Page: 39 / 70

MDS-1100R Series Chapter 3 Installation
0092642260-01 3-15
6) Remove two fixing bolts.
(Tool: Wrench 8mm)
Remove the cable holding plate and
rubber packing.
8) Pull in the connecting cable into the
scanner unit through the cable inlet hole.
Guide the cable to the cable holding plate.
Cable holding plate
Fixing bolt (8mm)
Rubber packing
7) The connecting cable CW-845-xxM
Blue tapes are wound as a mark on the cable.
Blue tape mark-b
Blue tape mark-a
Blue tape mark-c
Connecting cable
Cable inlet hole
5) This picture is the view of the inside of the
scanner unit housing.
( a ) Cable holding plate
( b ) Cable clamp-b
( c ) Cable clamp-c
( d ) Cable clamp-d
( a )
( b )
( c )
( d )