Koden MDC-7000P series, Installation Manual

Page: 54 / 152

Chapter 3 Installation Method MDC-7000P/7900P Series
3-32 0092669006-05E
3.4.8 Cable connection for inter-switch
3.4.8.1 Cable connection instructions for cross-over, dual and independent
connection
In case of a dual, cross-over, or master/slave connection using two sets of radar system or Display
unit, the remote cable and data cable are connected as shown in the figure 3.21.
(1) The heading, speed and latitude/longitude signals input to the data connector of master Display
unit and are supplied to the slave Display unit via remote cable. The slave Display unit can also
use ATA and chart option functions in the same way as the master one.
(2) Connect the slave Scanner unit to the slave Display unit in a crossover connection.
(3) Operation unit (MRO-108P) is required for MRD-108P.
Master Display unit
(MRD-108P/MRM-108P)
J7
Slave Display unit (MRD-108P/MRM-108P)
Connect slave Antenna
unit to slave Display unit in
the case of crossover
connection.
Data cable
SD05-1973 xxM
Figure 3.21 Connecting a slave Display unit on Crossover, dual and independent connection
Remote cable
CW-561-10M or 30M
(10m or 30m)
The device connected with radar must be
compliant with the following resolutions.
SDME: Resolution MSC.96 (72)
GPS: Resolution MSC.112 (73)
DGPS: Resolution MSC.114 (73)
THD: Resolution MSC.116 (73)
J8
J8 J3
J3
JB-35
JB-35