I. FINAL TEST FOR PRODUCT SAFETY
AT THE COMPLETION OF ANY REPAIR THE PRODUCT SHOULD BE ELECTRICALLY TESTED FOR
OPERATING AND ELECTRIC TEST AS FOLLOWS
ELECTRIC TEST
A). - Set hi-pot meter at 1500 V
B): -Place Switch Lock to on position.
c). -Touch one probes of tester to on blade of power cord plug and touch other probe to handle
tube. There should be no breakdown.
OPERATING TEST
RUN THE MACHINE ON HARD SURFACE WITH BRUSH OR PAD AND MAKE SURE:
A). - THERE IS NO UNUSUAL NOISE OR VIBRATION
B). - THE MOTOR STARTS FAST AND WITHOUT NOISE
C). - THE CURRENT DRAW IS LESS THAN 15 AMP.
II. - REPLACEMENT PROCEDURES ASSEMBLY
1. - INDUCTION MOTOR ASSEMBLY REPLACEMENT (8)
1.1.-Disconnect the line cord (3) from the motor line cord (97)
1.2. - Place the burnisher in face down position. Unscrew the center driver (45)
counterclockwise the three screws (44) as well as the base fix (43)
1.3.-Remove the six screws ( 43 ) the flex base ( 42 ) the five screws ( 41 ) five washers ( 40 )
and the plate ( 61 )
1.4.-Loosen the four screws (32) pull the motor from the pulley disc (29-D) remove the belt
1.5.-Remove the Allen screw (34) the motor pulley (35) as well as the locking pin (33) place the
burnisher in vertical position and remove the handle tube assembly.
1.6.-Remove the three screws ( 14 ) lift the motor cover ( 4 ) remove the connection box from
the motor, and disconnect the three terminals of the motor line cord assembly ( 3 ) and remove
the motor cover ( 4 ).
1.7.-Remove the bumper of the motor cover ( 6 ) the four screws ( 11 ), the two capacitor
covers ( 12 ), the two capacitor insulators ( 10 ), disconnect the two capacitors ( 9 and 15 )
1.8.-Place the burnisher in face down, remove the four screws (32) the washer (31) as well as
the four washers (30)
1.9.-Remove the motor (8)
1.10.-Replace the motor assembly (8) and reassemble
NOTE: When replacing the motor, make sure the replacement part the same features. It's
also important that both should be connected as initially placed in order to avoid
damages in the motor and alignment from pulleys.
3/12
September
/
2009
