KOBELT MANUFACTURING CO. LTD MNL-5027-A.docx (rev B)
18
5.
Rotate Clevis to desired position (1 full
turn of clevis = 0.025in/0.6mm of shoe
movement). Turn counterclockwise to
decrease clearance and clockwise to
increase.
6.
Return actuator to position and insert
pins, cotter pins and bolts.
Figure 1: Stroke Adjustment Reference Diagram
Note:
1.
When the brake linings are replaced it will be necessary to reset the clevises by turning
inward to allow for the extra thickness of a new lining.
5.3.3
Brake Linings
The linings must be replaced before the rivets make contact with the disc. Remove worn linings
from the shoe by drilling out the rivets with a ¼” drill. Install new linings with the proper rivets.
LINING REPLACEMENT
1. Remove bottom cotter pins from pins
‘E’.
2.
Remove pins
‘E’ by pulling upwards.
3.
Remove shoes by sliding radially forward to
clear the ends of the levers.
When re-installing the shoes into the caliper assembly,
be sure to re-
engage the balancing links “A”.
If there is insufficient room radially to remove the shoe,
then screws ‘C’ must be removed.
Summary of Contents for 5027-A
