35
Instructions manual |
www.grupotemper.com
KP 2102
Digital clamp meter
manual mode.
Press the “Hz/%”button again,
meter will be back to the condition
of the voltage or current measuring.
Note:
During working at maximum or
minimum value measuring function,
the meter can
’
t be changed into
frequency or duty cycle measuring
mode.
Switching Maximum Or
Minimum Value
press the maxim/minimum button to
enter into the maximum mode, the
maximum will always be measured.
and press this button again, it is the
same with the minimum.
After entering into
maximum /minimum mode, there
is no more analog function and
auto power off function will also be
canceled too.
After entering into
maximum/minimum mode, the
maximum/minimum data will be
recorded automatically.
Press the max/min button for more
than 2 seconds, it will be set into the
normal mode.
Note:
During measuring maximum or
minimum value, the meter will be set
to manual mode automatically.
During working at frequency or
duty measuring function, the meter
can
’
t be changed into maximum or
minimum value measuring mode.
Switching Functions
SELECT Key is a function selection
key that acts with trigger. Press the
key can choose the needed
measurement mode: To choose DC
or AC in DC/AC status, to choose
Diode or Buzzer in Diode/Buzzer
status, to choose Ohm, Cap, Diode
or Buzzer in Ohm/Cap/Diode/ Buzzer
status.
Press the key then turn on the
power, the Auto Power-off function
will be cancelled, the signal
“
APO
”
disappears in LCD, and enter into
Sleep Status (Power-Off). Press the
key then power on will have the Auto
Power-Off function.
Back Light And Clamp
Lighting Bulb
Press the
HOLD/B.L
button for
two or more seconds to switch on
the back light if the light in the
environment is too dim for taking
reading, which will last for 15
seconds.