7
ASSEMBLY INSTRUCTIONS
4
4. Pour paint into paint cup and put on cover
(See Fig 4. Oil and water extractor and air
compressor not included).
Load paint
OPERATION INSTRUCTIONS
Proper handling of the gun is essential for obtaining a good finish. The gun should be held at a
90 angle the surface being covered, and moved parallel to it. For precise control of the gun and
material, the trigger should be released before the end of the stroke. Hold the gun 6 to 12 inches
away from the surface depending on material and atomizing pressure. For a uniform finish, lap
each stroke over the preceding stroke, making sure the spray is smooth and wet. Using the
lowest possible atomizing air pressure will reduce over spray and provide maximum efficiency
(See Fig. 5)
.
O
6 to 12 inches
Start
stroke
Pull
trigger
Even and wet coat
Release
trigger
End of
stroke
RIGHT
Light coat
Heavy coat
WRONG
5
During normal use, the air cap wings are horizontal and the air cap should be pointed up as
shown here
(See Fig. 6)
.
This provides a vertical fan-shaped pattern which gives maximum and
even material coverage as the gun is moved back and forth parallel to the surface being finished.
The air cap wings
are horizontal.
6
