22
OPERATING INSTRUCTIONS
13. To Make a Bevel Cut
The bevel support allows making bevel cuts at 45°. You can choose different grooves to place
the cut at the desired spot on the tile.
a. Using a marker or grease pencil, mark the area to be cut on the tile.
b. Unfold the two bevel support legs. Align the grooves on the support legs with the grooves
on the sliding table (Fig. 13a and 13b).
NOTICE:
Make sure the bevel support (I) is set firmly in place before beginning cut.
c. Turn the saw ON, let the cutting wheel reach its full speed, and get wet before engaging
the tile into the cutting wheel.
d. Hold the tile firmly against the bevel support and feed the tile into the wheel.
e. When the cut is made, turn the saw OFF. Wait for the cutting wheel to come to a complete
stop before removing any part of the cut tile.
Bevel support can provide users with the function of corner cutting and the function of
chamfering the tiles.
Tiles of all thicknesses under 1 inch (25mm) are suitable for the first groove position (Fig.13c).
The second groove position is only suitable for chamfering tiles with a thickness of 23/32”
(18mm) or more. The typical marble thicknesses are 23/32” (18mm), 7/8” (22mm), 1” (25mm),
and 1-3/16” (30mm). Fig.13d shows the 1-3/16” (30mm) marble chamfering cut.
Figure 13e shows the chamfering cut of the 1-3/16” (30mm) marble tile when the bevel support
is installed in the 3rd groove position.
Summary of Contents for 4963562
