Kobalt 4963562, Manual

Page: 13 / 100

13
OPERATING INSTRUCTIONS
2. Preparations
Take all parts out of the packaging before
operation.
a. Make sure the battery pack is detached from
the saw.
b. Slide the sliding table (B) aside. Refer to
chapter “Table locking knob” later in this
manual.
c. Remove the miter guide (K) from the water
reservoir.
d. To remove the bevel support (I) out of the
reservoir, push the bevel support in the
direction of the buckle and remove it.
e. The miter guide (K), bevel support (I), wheel
wrench (J) and motor shaft wrench (S) can be
stored in the water reservoir after use (Fig. 2a).
To secure the bevel support (I) into the reservoir
(F) for storage, align the groove on the side of
the bevel support with the buckle and snap the
bevel support into the storage place.
2b
I
Buckle
2a
I B K J F
S