Kobalt 4913881, Manual

Page: 9 / 88

9
OPERATING INSTRUCTIONS
1. To Attach Battery Pack
a. Align the raised portion on the battery pack with
the grooves on the bottom of the tool, and then
slide the battery pack onto the tool as shown.
b. Make sure that the latch on the battery pack
snaps into place and the battery pack is secured
to the tool before beginning operation.
NOTICE: When placing the battery pack on the tool,
be sure that the raised rib on battery pack aligns
with the groove on the tool and the latches snap into
place properly. Improper assembly of the battery
pack can cause damage to internal components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull the battery pack backward to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
when the tool is not in use or when carrying the tool at your side.
2. Direction-of-Rotation Selector
(Forward/Center Lock/Reverse)
The direction of bit rotation is reversible and is
controlled by a selector located above the trigger
switch (C). With the impact wrench held in the
normal operating position, pointing away from you:
a. Position the direction-of-rotation selector (B) to
the left of the tool for forward rotation to tighten
the bolts.
b. Position the direction-of-rotation selector (B)
to the right of the tool for reverse rotation to
loosen the bolts.
c. Setting the selector in the center position locks
the trigger to helps reduce the possibility of
accidental starting when the tool is not in use.
NOTICE:
• To prevent gear damage, always allow the impact wrench to come to a complete stop before
changing the direction of rotation.
• The impact wrench will not run unless the direction-of-rotation selector is engaged fully to
the left or right.
TORQUE
Hand T
ight
Auto Slow
1
Battery-release
buttons
2
Forward
Reverse
B
B