9
OPERATING INSTRUCTIONS
1. To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, and
then slide the battery pack onto the tool as
shown.
b. Make sure that the latch on the battery pack
snaps into place and the battery pack is
secured to the tool before beginning operation.
NOTICE:
When placing the battery pack on the
tool, be sure that the raised rib on battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull the battery pack backward to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
when the tool is not in use or when carrying the tool at your side.
2. Direction-of-Rotation Selector
(Forward/Center Lock/Reverse)
The direction of bit rotation is reversible and is
controlled by the selector located above the trigger
switch (F). With the hammer drill held in the normal
operating position, pointing away from you:
a. Position the direction-of-rotation selector (E) to
the left of the tool for forward rotation to drill in
or drive the screws in.
b. Position the direction-of-rotation selector to the
right of the tool for reverse rotation to remove
screws.
c. Setting the selector in the center position locks
the trigger to helps reduce the possibility of
accidental starting when the tool is not in use.
NOTICE:
To prevent gear damage, always allow the hammer drill to come to a complete stop
before changing the direction of rotation.
NOTICE:
The hammer drill will not run unless the direction-of-rotation selector is engaged fully
to the left or right.
2
Forward
Reverse
1
Battery-release
buttons
