Kobalt 0790022, Manual

Page: 11 / 40

11
OPERATING INSTRUCTIONS
8. Adjustable Torque Clutch
The torque clutch can be adjusted to any of 24 torque
settings in the driving mode .
Adjust the torque by rotating the torque clutch (B).
The higher the torque setting, the more force the
hammer drill produces to turn an object.
The proper setting depends on the job and the type of
bit, fastener, and material you will be using. In general,
use greater torque for larger screws. If the torque is too
high, the screws may be damaged or broken.
Torque adjustment is not available for the drilling or
hammer mode.
CAUTION
• Do not change the torque setting when the tool is
running. This can damage the tool and cause loss of
control and possible injury.
9. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (I) with the hole on the
base of the hammer drill.
b. Insert the screw (K) and tighten the screw
securely with a Phillips screwdriver (not included).
c. To remove the belt clip, use a Phillips screwdriver
to loosen the screw holding the belt clip to the
hammer drill.
10. Installing and Removing the Bit Holder
a. Align the rib of the bit holder (J) with the hole on
the base of the hammer drill.
b. Insert the screw (K) and tighten the screw
securely with a Phillips screwdriver (not included).
c. To remove the bit holder, use a Phillips
screwdriver to loosen the screw holding the bit
holder to the hammer drill.
9
I
K
10
J
K
8
B