MedVault
®
Hardware Installation Instructions
OPE-MVHDWR-0202-H
The Knox Company ▪ MedVault
®
▪ 8
5.
Install the hinge lock security screws and finger-tighten.
6.
Use the Knox security screw removal bit to further tighten the security screws. DO NOT
OVER-TIGHTEN.
7.
Use a Phillips screwdriver to reattach the gas damper to the door.
8.
Use a screwdriver to open the door wire cover.
9.
Reconnect both halves of the coax cable and connector (if so equipped).
10.
Reconnect both halves of the Microfit connector.
11.
Secure the cables inside the door wire cover insuring that the wires are not kinked.
12.
Use screwdriver to close the door wire cover.
13.
Close the door, energize the unit, and verify the keypad lights up and the scrolling LED is
operational.
14.
Keep the Knox Security Bit in a secure location.