OPE-ESYSLR-0338-B
©Knox Company. All Rights Reserved
KNOX ELOCK CORE RETROFIT:
KLS-1500 KNOX HOMEBOX INSTALLATION GUIDE
3
1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 |
T.
800-552-5669 |
F.
623-687-2290 | [email protected] |
KNOXBOX.COM
CAUTION:
Activate Knox eKey and Knox eLock Core prior to installation!
The Knox
eLock Core and the Knox eKey must be activated before installation of the Knox
eLock Core. See the
KnoxConnect
™
Management System Administrator User
Guide
for further instructions.
KNOX ELOCK CORE INSTALLATION
Assemble the Knox eLock Core:
Line up the sidebar of the Knox eLock
Core with the groove in the Lock Shell
and slide the Lock Core into the Lock
Shell from the outside of the door.
Insert the Dust Cover, Dust Cover
Bracket, and the Knox eLock Shell into
the outside of the door as shown in
Figure 2
on Page 1.
Install the Lock Shell Nut onto the Lock
Shell from the inside of the door. Ensure
the tab on the Lock Shell is orientated to
the left.Use a 7/8" socket or wrench to
tighten the nut to snug.
3
1
2
Reinstall the Cam Stop Washer onto
the Lock Core from the inside of the door.
Insert the Shim Washers up against the
Stop Washer. Reinsert the Lock Cam
followed by the Lock Washer. Reinstall
and hand tighten the Lock Cam Nut.
4
5
6
Close the door, rotate the Knox eKey
clockwise, and remove the key.
9
To ensure the Knox eLock Core
installation was successful, test the
Knox eLock Core BEFORE closing the
box. Enter your command code, insert
the Knox eKey, and rotate the key
counter-clockwise.
8
Using the activated Knox eKey, turn the
lock to the unlock position. Place a screw
driver next to the edge of the Cam as
shown below to prevent the Cam from
turning, and tighten the nut to snug using
a 9/16" socket or wrench.
7
IMPORTANT:
Ensure that the Stop Washer is
orientated as shown in the image above.
Enter your command code and
insert the Knox eKey into the Knox
eLock Core to unlock the unit
(see
steps below picture).
a.
Rotate the Knox eKey 90° counter-clockwise.
b.
Check the inside of the door to make
certain the Stop Washer is in place and
has not slid off the Lock Core. If so,
re- secure the Stop Washer.
c.
If the key turns clockwise rather than
counter-clockwise, go back to Step 4 and
change the position of the Stop Washer.
WARNING!
Upon reinstallation of the Lock Cam,
DO NOT CLOSE AND LOCK THE BOX!
NOTE:
Cam shown in the locked position above.
IMPORTANT!
Do not attempt without using
screwdriver. This will prevent
damage to the Knox eLockCore
while tightening the nut.