KNOVA KN RO-1304, Manual

Page: 6 / 20

APPLICATIONS
4) Hold the trimmer closely to operate the trimmer in a
circle as defined by the screw as follow.
4. USING THE BASE GUIDE
1) Loosen the clip knob A to install the base guide on
the base plate of the trimmer.
2) Loosen the clip knob B and adjusting knob to get
the desired distance between the base guide and
milling cutter.
Nail
Center
point
Line guide
3) Tighten clip knob B to secure the base guide in place.
4) Hold the trimmer firmly as below.
5) During cutting, make sure the rubber block on base
guide keep flush and advancing smoothly along
the edge of work piece.
Trimming guide
Tight screw A
Adjusting screw
Tight screw B
Milling cutter
Block
Trimming guide
Work
piece