KNOVA KN RO-1304, Manual

Page: 4 / 20

OPERATION
Milling cutter
Transparent guard
Lock handle
Rubber roller
Graduate scales
4) SWITCHING ON AND OFF
WARNING
To reduce the risk of injury, to make sure
you can control the switch freely and keep it off before
plugging the trimmer. To switch on ,turn it at “I”
position, and to switch off, push it at “O” position.
Switch
5) EDGE TRIMMER
(1) Place the base plate on the work piece ensuring that
milling cutter is not in contact with the material to be
cut.
(2) Connect the trimmer to the power supply. And then
turn it on. Ensure you have a firm grip on both
handles. Wait for milling cutter to attain full speed.
(3) Lower the trimmer and move it over the work piece
surface, Keeping the base plate flush and advancing
smoothly until cutting is complete.
(4) Keep the cutting pressure constant, taking care
not to crowd the trimmer causing the motor to slow
excessively.
(5) To turn the trimmer off, release the switch.
WARNING
Always use two hands to holdnthe trimmer,
Where possible, clamp the work piece to the bench.
APPLICATIONS
WARNING
To reduce the risk of injury, never touch
the milling cutter to clean the debris until it has
already stoped and cooled down
1. APPLICATION HINTS
1) When cutting flat panels such as kitchen work surfaces,
before joining please ensure that you use an appropriate
jig together with the correct guide bush. DO NOT use
the curved part of the trimmer
2) Always apply pressure in line with the cutter. Use
enough pressure to keep cutting, but do not push hard
enough to stall the motor.
3) On very hard woods or problem materials it may be
necessary to make more than one pass at progressive
cutting depths until the desired depth of cut is achieved.
When cutting groove, the recommended cutting depth
should no more than 3mm.
4) When edge cutting, the work piece surface should be
on the left side of the milling cutter in the feed direction.
Moving direction
Cutter rotating direction
Cutter rotating direction
Workpiece
Moving
direction
Correct cutter moving direction
Workpiece
Line guide
Moving direction
Cutter rotating
direction