ADJUSTMENT
Fig. AA
Laser
warrning label
Laser
aperture label
NOTE: If laser
labels are
missing,
damaged or
not clear,
contact with
the Knova
Service Centre
for replacement.
LASER GUIDE ADJUSTMENT (FIG. BB, CC, DD, EE)
NOTE: All the adjustments for the operation of this machine
have been completed at the factory. Due to normal wear and
use, some occasional readjustments may be necessary.
A. Checking Laser Line Alignment (Fig. BB, DD)
1. Set the saw to a 0° miter and 0° bevel setting.
2. Use a combination square to mark a 90° angle running
across the top and down the front of a board. This line will
serve as the pattern line (Fig. DD) to adjust the laser.
Place the board on the saw table.
3. Carefully lower the saw head down to align the saw blade
with the pattern line. Position the saw blade to the left,
center or right side of the “pattern line” depending on your
preference for the laser line location. Lock board in place
with hold-down clamp.
4. With the saw plugged in, turn on the Laser guide. Your saw
has been preset with the laser line to the left side of the
blade.
B. Adjusting the Position of the Laser Line (Fig. CC, DD, EE)
Front Line (Fig. CC, DD)
If the laser line is angled from left to right, turn the laser
vertical adjustment knob (1) counterclockwise to align the
laser line parallel with pattern line. If the laser line is angled
from right to left, turn the knob clockwise to align the laser
line parallel with pattern line.
Top Line (Fig. CC, EE)
If the laser line is angled from left to right, turn the laser
horizontal adjustment knob (2) clockwise to align the laser
line parallel with pattern line. If the laser line is angled from
right to left, turn the knob counterclockwise to align the laser
line parallel with pattern line.
After performing the above adjustments, visually check that
both the front and top laser lines are parallel with pattern line.
NOTE:
• Laser line is calibrated and set up to project to the left
of the blade.
• If you have any problem
or questions
concerning the
laser guide, call
the following
number for
assistance:
01-800-70-56682.
5. Looking at the front of the board, if the laser line is not
parallel to the “pattern line” please follow the instructions
listed below under “Front Line” paragraph.
6. Looking at the top of the board, if the laser line is not
parallel to the “pattern line” please follow the instructions
listed below under
“Top Line” paragraph.
WARNING
To prevent serious injury, insert a padlock
(not provided) through the hole in the ON/OFF Trigger
Switch prior to making any laser adjustment. DO NOT
remove the lock from the ON/OFF Trigger Switch
during any laser adjustment.
WARNING
When making laser line adjustments, keep
fingers away from the ON/OFF trigger switch to
prevent accidental starting and possible serious injury.
Fig. BB
Laser line
Workpiece
TOP VIEW
Laser line
Cutting
line
Cutting line
Blade
Fig. CC
Fig. DD
Fig. EE
Counterclockwise
Counterclockwise
Pattern line
Pattern line
Laser line
Laser line
Clockwise
Clockwise
1
2
16
Summary of Contents for KN M-3059R
