KNOVA KN CM-11MA, Manual

Page: 4 / 24

3
ELECTRICAL REQUIREMENTS
WARNING
Improper connection of equipment grounding
conductor can result in the risk of electrical shock.
equipment should be grounded while in use to
protect operator from electrical shock.
-Check with a qualified electrician if you do not understand
grounding instructions or if you are in doubt as to whether
the tool is properly grounded.
-This tool is equipped with an approved cord and a 3-prong
grounding type plug for you protection against shock
hazards.
-Grounding plug should be plugged directly into a properly
installed and grounded 3-prong grounding-type receptacle,
as shown.
-Do not remove or alter grounding prong in any manner.
in the event of a malfunction or breakdown, grounding
provides a path of least resistance for electrical shock.
WARNING
This machine is for indoor use only. Do not expose to
rain or use in damp locations.
GUIDELINES FOR EXTENSION CORDS
USE PROPER EXTENSION CORD.
Make sure your
extension cord is in good condition. When using an extension
cord, Be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in
line voltage, resulting in loss of power and cause overheating.
Be sure your extension cord is properly wired and in good
condition. Always replace a damaged extension cord or have
it repaired by a qualified person before using it. Protect your
extension cords from sharp objects, excessive heat and damp
or wet areas.
ACCESSORIES AND ATTACHMENTS
WARNING
To avoid injury:
• Use only accessories recommended for this machine.
• Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
• Use only accessories designed for this machine to avoid
injury from thrown broken parts or work pieces.
• Do not use any accessory unless you have completely
read the instruction or operator’s manual for that
accessory.
CARTON CONTENTS
UNPACKING AND CHECKING CONTENTS
Carefully unpack the machine and all its parts, and compare
against the illustration following.
WARNING
• To avoid injury from unexpected starting, do not plug
the power cord into a power source receptacle
during unpacking and assembly. This cord must
remain unplugged whenever you are assembling
or adjusting the machine.
• If any part is missing or damaged, do not plug the machine
in until the missing or damaged part is replaced, and
assembly is complete.
TABLE OF LOOSE PARTS
Unpack carton; check you machine to see parts listed below:
1. Jointer
2. Fence
3. Fence support
assembly
4. Fence sliding base
5. Spring
6. 4mm Hex wrench
7. Lock handle
8. Flat washer
9. Square nut
10. Filter bag
11. Dust chute
12. Push block
13. Push stick
10
1
5
2
11
3
4
6
12
13
7
8
9