FOR YOUR SAFETY.
Please read these instructions carefully and retain them for future use.
Safety Information
The use of a Hydraulic Pipe Bender has
inherent dangers. To avoid risk of personal
injury or property damage make sure you
are fully aware of the operating instructions
for this product. The recommendations in
this manual can not cover all eventualities.
This tool is designed and intended for use by
properly trained and experienced personnel.
If you are not familiar with the proper and
safe operation of a hydraulic pipe bender, do
not use until proper training and
knowledge has been obtained.
Do not exceed working load limit of this pipe
bender. This Pipe bender is intended for
bending heavy water and galvanized pipe.
Do not use for any other purpose except
those listed in this manual; do not attempt
to bend objects that could shatter.
Warnings
The Hydraulic jack used in this pipe bender
is designed for use within the pipe bender
only. It is not suitable for any other
application. DO NOT use this jack for any
form of lifting, it is neither designed for nor
suitable for lifting applications.
Assembly
No assembly is required so it is important
to check all bolts and nuts are tight and
familiarize yourself with the assembled
Pipe Bender. Selection of the correct die to
match the diameter of the pipe to be worked
on and adjustment of the guide rollers may
be required to achieve the required bend.
Operation
Preparing Work Area:
Before using the pipe bender, it is important
to prepare work area properly. Follow this
procedure each time the pipe bender is used
to help prevent property damage and or
serious injury.
SPECIFICATIONS
1.
Thoroughly inspect pipe bender for
damage or 1. Thoroughly inspect pipe
bender for damage or wear before each
use. Briefly test operation of unloaded
hydraulic jack before using to bend any
job. If jack is damaged or is
malfunctioning DO NOT USE until the
problem is corrected.
2.
Consult owner’s manual for safety
precautions correct use and
recommended procedures before using
the pipe bender. The working load limit of
the hydraulic jack is 16,000 kg. NEVER
EXCEED WORKING LOAD LIMIT OF
HYDRAULIC JACK.
3.
Keep children away and others people
from work area before using the pipe
bender. Another adult should be nearby
for extra safety and assistance but must
be away of the bender when it’s used.
4.
Never use to compress bend objects that
could be ejected from the bender. Do not
try to bend objects that could shatter.
5.
Clean obstructions the work area.
Working in tight or cluttered work areas
is dangerous.
6.
Ensure pipe bender and operator are on
solid, level ground such as paved or
concrete driveway or garage floor.
Uneven or sloped surfaces create
hazardous working conditions and may
dangerously impede the function of
the pipe bender.
Handle - Handle Wrench:
With the hydraulic jack on a level surface
place the handle wrench over release valve.
Turn handle slowly clockwise until firm DO
NOT over tighten. Remove handle from
release valve and slide handle into handle
base on hydraulic jack, jack is now ready to
be raised.
Model
KN 7410-16
Load capacity:
16,000 kg.
Maximum bending
capacity:
a ≤ 90°
Tube size range:
1/2” - 3”
Bending dies:
1/2”, 3/4”, 1”, 1-1/ 4”,
1-1/ 2”, 2”, 2-1/2”, 3”.
Net/gross weight:
58 / 60 Kg.
