Gaskets
Fig 7
•
Remove the bezel by turning anti-clockwise 90°
•
Insert a GU10 lamp into the lamp clip (please note the bezel is designed for the lamp to sit on top and not inside)
•
Secure lamp into the GU10 lamp holder
•
Push the bezel and lamp into position within the fitting and secure bezel by turning 90° clockwise
•
Switch on power supply and check for correct operation
WARNING
These products are IC rated and are suitable for use with glass/mineral wool insulation which can be laid loosely unbroken
over the luminaire. The insulation should NOT be packed around the product. We do not recommend the use of other
types of insulation material to be used with these downlights
A space of at least 50mm should be left between the luminaire and any surface (such as joists)
GENERAL
The product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where
facilities exist
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the product
WARRANTY
This product has a warranty of 1 year from date of purchase. Failure to install in accordance with the current edition of the
IEE Wiring Regulations, improper use, or removal of the batch codes will invalidate the warranty. If this product should fail
within its warranty period it should be returned to the place of purchase for a free of charge replacement. ML Accessories
does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are
not affected. ML Accessories reserve the right to alter product specification without prior notice
4
ML Accessories Limited
LU5 4LT
www.mlaccessories.co.uk
SBJUN18_V2
• When using an IP65 bezel, please ensure both
gaskets are in place. One gasket is pre-installed
with the bezel and the second gasket should be
installed around the base of the fitting (see Fig 7)
• Remove the bezel by turning anti-clockwise 90°
• Insert a GU10 lamp into the lamp clip (please note
the bezel is designed for the lamp to sit on top and
not inside)
• Secure lamp into the GU10 lamp holder
• Push the bezel and lamp into position within the
fitting and secure bezel by turning 90° clockwise
• Switch on power supply and check for correct
operation
These products are IC rated and are suitable for use with glass/mineral wool insulation which
can be laid loosely unbroken over the luminaire. The insulation should NOT be packed around the
product. We do not recommend the use of other types of insulation material to be used with these
downlights.
A space of at least 50mm should be left between the luminaire and any surface within the void
(such as joists etc.)
The product should be recycled in the correct manner when it reaches the end of its life. Check
local authorities for where facilities exist
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may
damage the product
This product has a warranty of 1 year from date of purchase. Failure to install in accordance with
the current edition of the IEE Wiring Regulations, improper use, or removal of the batch codes will
invalidate the warranty. If this product should fail within its warranty period it should be returned
to the place of purchase for a free of charge replacement. ML Accessories does not accept
responsibility for any installation costs associated with the replacement product. Your statutory
rights are not affected. ML Accessories reserve the right to alter product specification without
prior notice
WARNING
GENERAL
WARRANTY
Fig 7
