These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance
These instructions should be used to aid installation of the following product:
EMSUR
GENERAL INSTRUCTIONS
SAFETY
INSTALLATION
• Installation of this luminaire should only be carried out by a qualified electrician or competent person
to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for
installation
• Installing in areas where the temperature consistently drops below 0°C may shorten the battery life
• We recommend a minimum charge period of 24 hours before carrying out an emergency duration test
• This product is Class II double insulated
• This product is non-dimmable
• This product is IP20 rated
• Provide power to the required point of installation. Suitable IP rated junction boxes should be used
where required
• Remove the baseplate by pressing the two retaining tabs on either side of the fitting (see Fig 1)
• Using the baseplate as a template, mark the location of the fixing holes, and drill the holes ensuring
not to infringe with any joists, gas/water pipes or electrical cables
• Ensuring correct polarity is observed, wire as shown in Fig 2
Fig 1
EMSUR
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance
These instructions should be used to aid installation of the following product:
EMSUR
SAFETY
•
Installation of this luminaire should only be carried out by a qualified electrician or competent person to the
latest Building and current IEE Wiring Regulations (BS7671)
•
Please isolate mains prior to installation/maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for installation
•
Installing in areas where the temperature consistently drops below 0°C may shorten the battery life
•
We recommend a minimum charge period of 24 hours before carrying out an emergency duration test
•
This product is Class II double insulated
•
This product is non-dimmable
•
This product is IP20 rated
INSTALLATION
•
Provide power to the required point of installation. Suitable IP rated junctions boxes should be used where
required
•
Remove the baseplate by pressing the two retaining tabs on either side of the fitting (see Fig 1)
Fig 1
•
Using the baseplate as a template, mark the location of the fixing holes, and drill the holes ensuring not to
infringe with any joists, gas/water pipes or electrical cables
•
Ensuring correct polarity is observed, wire as shown in Fig 2
Fig 2
Press retaining tabs
L
N
Live (brown)
Neutral (blue)
2
