• For maintained non-switched operation, carefully wire as shown in Fig 4
Fig 3
Fig 4
Battery
PCB
• Connect the battery to the inverter via the plug and socket provided
Battery
PCB
• Refit the gear tray by pushing down until the tabs click into place
• Place diffuser in line with the 2 screw holes and fasten screws down
• Switch on the power supply and ensure the LED indicator is illuminated Green.
If it is not illuminated Green, there may be a battery fault
• A self-adhesive legend kit has been supplied with this product should it be required
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation
resistance testing. Irreparable damage will occur if this instruction is not followed.
GENERAL
The LEDs fitted in this product are non-replaceable. The unit should be recycled in the correct
manner when it reaches the end of its life. Check local authorities for where facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may
damage the fitting.
WARRANTY
This product has a warranty of 3 years (excluding the battery) from date of purchase. Failure to install
this product in accordance with the current edition of the IEE Wiring Regulations, improper use, or
removal of the batch codes will invalidate the warranty. If this product should fail within its warranty
period it should be returned to the place of purchase for a free of charge replacement.
ML Accessories does not accept responsibility for any installation costs associated with the
replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter
product specification without prior notice.
