Knight UniTech Warewash, Instruction Manual

Page: 14 / 24

Page 14 of 24 0900591 Rev: A (07/04)
ADDING A SANITIZER PUMP
Adding an optional sanitizer pump to an existing 2-
product system requires just a few simple steps. The
sanitizer pump is normally mounted on the right side (as
you face the unit) of the UniTech dispenser, however
can be mounted on the left side if necessary.
(1) Turn the unit over and lie it down, preferably on a
smooth surface that won’t scratch the display.
(2) Remove the cover on the right-hand side of the unit
by gently prying it up with a flat screwdriver tip.
(3) Line up the sanitizer pump in the slot on the Uni-
Tech. Ensure the 4-pin (bus) connectors are
aligned and slowly slide the pump into place.
(4) Insert the two provided screws and tighten.
(5) Set the DIP switches (back of sani pump) so that
switch #1 is ON and all other switches are OFF.
(6) Process complete! Now ready for mounting.
Display Shown on Power Up
When the UniTech dispenser is powered up for the first time after adding a sanitizer pump, the system will
automatically check for new devices and the following display will appear.
This display shows that UniTech has recognized the sanitizer pump
connected to the bus. The #1 indication simply means that this is the first
“satellite” pump added to the unit. This message will appear briefly, then the
system will automatically advance on to the normal display.
NOTE: A sanitizer pump is the only satellite pump that can be added to a
UniTech warewash unit.
500 PMP Found
Device #1 = Sani