KneeCycle Set Up Instructions:
Please follow the step by step instructions on the following pages to
properly assemble your KneeRover
®
scooter. The diagram below
identifies the key components of the scooter to aid with assembly.
Step 1: Install Front Axle
Please take your time to carefully complete all steps before operating
your new KneeRover
®
scooter. First, place the front axle with caster
wheels under the scooter frame, ensuring the round bolts by the wheels
are facing up (as shown in left and right photos). Align the axle and frame
holes, insert the clamp and washer into each hole, and tighten the clamps
in a clockwise motion until the axle is tight against the frame. Press the
clamp lever down firmly until it touches the frame, to lock it in place. The
right photo shows how the clamp should look when properly installed.
Step 2: Install Steering Mechanism
Attached to the front axle you will see two gray bars (the tie rods). Take
one of the tie rods and position it under the black plate that is attached to
the frame. Next take the other tie rod and place it on top of the black
plate. Place the washer on top of the upper tie rod and then thread the
bolt from the bottom to the top, through the tie rods. Finally thread the
cotter pin through the hole on top to lock the assembly in place.
Weight Capacity = 300 pounds
Hand Brake Lever
8” Non Marking
Wheels
Basket
Adjustable Knee
Platform
Handlebar Height
Adjustment Knob
Quick Release
Clamp
Steering Column
Brake Cable
Rear Brake
Mechanism
Removable Front
Axle
Clamp
Lever
Washer
Round Bolt
Proper Assembly of Tie Rods:
Black Plate
Upper Tie Rod
Washer
Cotter Pin
Lower Tie Rod
Bolt
