KneeRover
®
Set Up Instructions:
Please follow the step by step instructions on the following pages to
properly assemble your KneeRover
®
All Terrain scooter. The
diagram below identifies the key components of the scooter to aid
with assembly.
Step 1: Install Steering Column
The steering column will be in a folded position when unpacking.
When facing the front of the KneeRover
®
scooter, raise the steering
column and push the security pin in the clamp to the left (as shown
in the left photo) to allow the column to lock into place. Raise the
clamp lever upward and tighten by turning it clockwise. Finally,
push clamp lever down firmly to secure the steering column (as
shown in the right photo). Reverse these steps when needing to
lower steering column for transport. Once knee platform is installed,
use the black knob (shown in bottom photo) to set the handlebars at
a comfortable height for operation.
Hand Brake Lever
Pneumatic
12” Wheel
Brake Cable
Knee Platform
Handlebar Height
Adjustment Knob
Quick Release Clamp
Knee Platform
Clamp
Steering Column
Basket
Rear Brake
Mechanism
Tie Rods
Steering Mechanism
Weight Capacity = 400 pounds
Push Pin to Left
