Unpacking and setup
8
AZURA® Valve Unifier VU 4.1 Instructions V6855
Unpacking and setup
This chapter describes all preparatory steps prior to start-up.
Operating environment
Only if the requirements for ambient conditions of the operating environment
are met, can the intended use be ensured. You will find the ambient condi-
tions under Technical Data.
Device defect
The device overheats at exposure to sunlight and insufficient air circulation.
Device failures are very likely.
Set up the device in such a way that it is protected against exposure to
direct sunlight.
Leave some space for air circulation: See space requirements.
Space requirements
At least 5 cm, if there is another device on one side.
At least 10 cm, if there are devices set up on both sides.
General requirements
Position the device on a level surface.
Protect the device against direct exposure to sunlight.
Set up the device at a location not exposed to air drafts (A/C systems).
Do not set up the device near other machines that cause floor vibrations.
Avoid sources of high frequencies near the device. High-frequency sources
may compromise measuring values.
Unpacking the device
Prerequisite
Check packaging for damage caused during transportation. If necessary, put
forward any claim for damages to the carrier.
Tools
Utility knife
Bruising danger
Damage to the device by carrying or lifting it on protruding housing parts.
The device may fall and thus cause injuries.
Lift the device only centrally on the side of the housing.
